Porter Cable PCE380 Manual De Instrucciones página 10

TO USE THE LASER LINE
• Mark the line that you intend to cut on the
workpiece.
• Adjust the depth and angle of cut as
required.
• Turn the laser on and project the laser
beam.
• Depress the saw trigger switch (1) and allow
the blade to reach maximum speed.
• Place the saw shoe on the workpiece. Align
the laser line with the mark on the workpiece
and slowly push the saw forward keeping
the laser line on the mark.
• Upon completion of the cut, release the
trigger and allow the saw blade to come
to a complete stop before switching off
the laser.
14
CLEANING THE LASER LIGHT LENS
If the lens for the laser light becomes dirty,
or sawdust adheres to it in such a way that
the laser line is no longer easily visible,
unplug the saw and clean the lens carefully
with a damp, soft cloth. Do not use solvents
or any petroleum based cleaners on the
lens.
Note: When laser line is dim and almost
or entirely invisible because of the direct
sunlight in the indoor or outdoor window
near your work area, relocate the work area
to a place not exposed to direct sunlight.
Note: All of the adjustments for the
operation of this machine have been carried
out at the factory.
CAUTION:
Use of controls or
adjustments or performance of
procedures other than those specified
herein may result in hazardous radiation
exposure. The use of optical instruments
with this product will increase eye hazard.
Do not attempt to repair or disassemble the
laser. If unqualified persons attempt to repair
this laser product, serious injury may result.
Any repair required on this laser product
should be performed by authorized service
center personnel.
PLUNGE CUTTING (FIG.15)
• To operate the tool, first depress the
trigger lock and shoe release button
(10), then squeeze the on/off switch (1).
WARNING:
full speed before the blade enters into
the workpiece.
• Tilt tool forward with line-of-cut indicator
(20) lined up with desired line of cut
marked on the workpiece. Gradually
move tool forward.
WARNING:
15
12a
20
USING THE PARALLEL GUIDE (FIG.16)
• For making exact cuts along a
workpiece edge.
• Can be inserted in either side of foot.
ADJUSTING PARALLEL GUIDE
• Loosen knob (5)
• Adjust to desired cutting width by using
parallel guide scale (use line-of-cut
indicator (20) as 0-reference).
• Tighten knob (5).
16
TIPS FOR OPTIMUM USE
WARNING:
coated wood, and other materials may
cause melted material to accumulate on
the blade tips and the body of the saw
blade, increasing the risk of blade
overheating and binding while cutting.
• Only use sharp saw blades of the
correct type and size (fig. 17).
• Use hardened steel saw blade (17) for
10
The tool should run at
Never pull tool backwards.
12
Cutting plastics, sap