Acson international CEEW Serie Manual De Instrucciones página 5

7. How To Remove Air Inlet Grille
Air Inlet Grille
Air Inlet
Grille Holder
Rib
Grille Holder (L/R)
• Remove the air inlet grille by both hands as the direction
shown.
• Loosen the screw for fixing the panel arm (3 screw,
left, right and center). Do not remove the screw at this
time.
• Move the air inlet grille upward, and then turn it
backwards. (Do not use too much force).
• Remove the grille holder (both left and right side). After
that, remove to air intake grille.
• Remove the grille holder (center) from the panel.
• The indoor unit is equipped with water outlet and inlet bare connection. There is an air-vent for air purging that is
fitted at the outlet water header. 3 way valve is required for cycling off or bypass the chilled water.
• Black steel pipe, polyethrene pipe, PVC pipe and copper tube are recommended in field installation.
• All of types of piping and connection must be insulated by polyurethane (ARMAFLEX type or equivalent) to avoid
condensation.
• Do not use contaminated or damaged pipe and fitting for installation.
• Some main fitting components are needed in the system to enhance the capacity and ease of service, such as gate
valve, balancing valve, 2 way or 3 way valve, filter, strainer etc.
Chiller
Screw
Grille Holder (Center)
(Optional)
Axis of the
Front Panel
Grille Holder (Center)
WATER PIPING CONNECTION
Gate Valve
Three Way Valve
FCU
Gate Valve
Good Controlling
8. How To Install The Air Filter
(A)
(B)
Install the filter to the panel in the (A)
direction follow by (B) to secure the filter.
9. To Adjust The Vane Direction
Adjust the vane linkage as the direction shown to get the
required vane direction
10. Dimension Of The Fresh Air Intake Hole
Ø 64.0
Gate Valve
Two Way Valve
FCU
Gate Valve
Bad Controlling
4
(A)
(B)
Snap in the filter in order to secure it
Ø 3.0
70.0
Gate Valve
FCU
Gate Valve
Worst Controlling