Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the clock
Before you start operating the air conditioner, set the clock of the
remote controller using the procedures given in this section. The clock
panel on the remote controller will indicate the time regardless of
whether the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote controller, the clock panel
will indicate AM 0:00 and will flash.
1 ON/OFF TIMER button
1
1
1
1
Push
or
button to set the current time.
Each push of the TIMER button changes the time in one minute steps.
Pushing the TIMER button continually changes the time in ten
minute steps.
2
2 SET
2
2
2
button
Push the SET
button.
The current time is indicated and the clock starts.
Clock adjusting
1
1
1 CLOCK button
1
1
Push the CLOCK button.
The CLOCK display flashes.
2 ON/OFF TIMER button
2
2
2
2
Push
or
button to set the
current time.
Each push of the TIMER button
changes the time by one minute.
Pushing the TIMER button
continually changes the time by
ten minutes.
3
3
3 SET
3
3
button
Push the SET
button.
The current time is indicated and the
clock starts.
Preparing the filters
1 Open the air inlet grille, and
1
1
1
1
remove the air filters.
2
2
2
2 Attach the supplied
2
Sasa-Zeolite plus filter
and Bio-enzyme & Gingko
filter (two each).
1
Push
CLOCK
2
Sasa-Zeolite plus filter
6
Bio-enzyme &
Gingko filter
1
2
2
3
1
EN
Publicidad
Tabla de contenido
