DeWalt D21585 Traducido De Las Instrucciones Originales página 27

10. Connect dust extraction equipment.
If the tool is provided for the connection of dust
extraction and collecting equipment, ensure
these are connected and properly used.
11. Do not abuse the cord.
Never yank the cord to disconnect it from
the socket. Keep the cord away from heat, oil
and sharp edges.
12. Secure work.
Where possible use clamps or a vice to hold the
work. It is safer than using your hand.
13. Do not overreach.
Keep proper footing and balance at all times.
14. Maintain tools with care.
Keep cutting tools sharp and clean for better
and safer performance. Follow instructions for
lubricating and changing accessories. Inspect
tools periodically and if damaged have them
repaired by an authorized service facility. Inspect
extension cords periodically and replace if
damaged. Keep handles dry, clean and free
from oil and grease.
15. Disconnect tools.
When not in use, before servicing and when
changing accessories such as blades, bits and
cutters, disconnect tools from the power supply.
16. Remove adjusting keys and wrenches.
Form the habit of checking to see that adjusting
wrenches are removed from the tool before
turning it on.
17. Avoid unintentional starting.
Insure switch is in the "off" position before
plugging in.
18. Use outdoor extension leads.
When the tool is used outdoors, use only
extension cords intended for outdoor use and
marked accordingly.
19. Stay alert.
Watch what you are doing. Use common sense
and do not operate the tool when you are tired.
20. Check for damaged parts.
Before furture use of tool, it should be carefully
check to determine that it will operate properly
and perform its intended function. Check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting and any
other conditions that may affect its operation. A
guard or other part that is damaged should be
properly repaired or replaced by an authorized
service centre unless otherwise indicated in this
instruction manual. Have defective switches
replaced by an authorized service centre.
Do not use the tool if the switch does not turn
it on and off.
WARNING! The use of any accessory
or attachment other than one
recommended in this instruction manual
may present a risk of personal injury.
21. Have your tool repaired by a qualified
person.
This electric tool complies relevant safety rules.
Repairs should only be carried out by qualified
persons using original spare parts; otherwise
this may result in considerable danger to the
user.
Additional Specific Safety Rules for
Diamond Drills
• Bits, tools and drilling area get hot during
operation. Wear gloves when touching
them.
• Use the diamond drill under constant
supervision.
• Make sure not to cut through electric mains,
gas or water pipes. Use detection systems
prior to drilling.
• Make sure the cutting accessory is fitted
properly.
• Check all screws and tighten securely before
you use the machine.
• When drilling downward, make sure the core
can drop safely without injuring someone
standing beneath.
• Make sure to stand on a stable surface and
keep body balance at all times for better
control of reaction torque.
• Inspect the machine before every use. Do not
use the machine if there are any defectives
on the mains plug, power cord, trigger switch
or any part of the housing. Have the machine
repaired by an authorized repair agent.
• Do not use the machine in a damp or wet
location.
• Switch off the machine immediately if there is
any leak of water.
• After interrupting the cut, do not switch on
until the core bit can rotate freely.
• Always switch the tool off to prevent the
machine from accidentally self starting.
Note this procedure especially after the
power supply is interrupted or the plug is
disconnected from the power outlet.
• In case of jammed core bit disconnect the
machine from the power supply, remove
the reason for the jam before turning on the
machine again.
english
25