Guide Bar - Ducati DCS 5500R Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Place your file on the cutter and push straight forward. Keep the file position as illustrated.
File diameter
Type of chain
72V
Depth gauge

Guide bar

• Reverse the bar occasionally to prevent partial wear.
• The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise, the bar rail is
worn. Such a bar needs to be corrected or replaced.
WARNING
The table contains a list of all possible combinations between bar and chain, indicating
those which may be used on each machine, marked with the symbol "*" .
Pitch
Guide bar
Length
Zoll
Inches/cm
0.325"
16"/40cm
0.325"
18"/45cm
0.325"
20"/50cm
For replacement use only above bars and chains. If you use non‐approved combinations it may cause
serious personal injury and damage to the machine
Top plate angle
Vise rotate
angle
7/32"
25°
Groove width
Code Oregon
Inch./mm
0.058"/1.5mm
168PXBK095
0.058"/1.5mm
188PXBK095
0.058"/1.5mm
208PXBK095
Owner's manual
Head tilt angle
Down angle
(55°)
Vise tilt angle
Side angle
10°
60°
Chain
Number of
Code Oregon
nose teeth
10
21BPX066X
10
21BPX072X
10
21BPX078X
English
Depth gauge
standard
0.025"
File
(1) Ruler
(2) Gap
(3) No gap
(4) Chain tilts
Number of
drive links
66
72
78
45

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido