Publicidad
RTS554 Instructions
3
4a
AUS/NZ Ranger
T9
Page 6 of 12
165mm
B
A
B
T11
A. Knife cut the rear section of
A. Slice the trim exactly on the line in the
the trim exactly on the line in the
moulding location marked in steps 2a & 3.
moulding location. The line is
approximately 185mm from the
back edge of the moulding.
B. Make sure you apply protection
on both sides of the track to
prevent the knife from slipping and
Work back & forth to snap the stainless
marking the roof.
steel core in the rubber trim
C.
the rear edge of the trim until the
double sided tape lets go.
B. Make sure you apply protection on both
sides of the track to prevent the knife
from slipping and marking the roof.
Publicidad
