Cooper Lighting MD42FLB Instrucciones página 4

MD42FLW_FLB 825-0418.qxd:MD Series 325-1432.qxd
Step 1: Feed the supply wires from the house through the
lampholder mounting gasket, and through the back
of the mounting plate itself (Fig. 2).
Step 2: Install the lampholder mounting plate to the junction
box (refer to the mounting plate instructions).
House supply wires should be sticking out of the
front of the mounting plate.
Step 3: Screw the locknut (found in the hardware bag)
onto the threaded end of the mounting plate
adapter (G). Feed the supply wires from the
house (coming through the lampholder mounting
plate hole) through the mounting plate adapter
hole (Fig. 3). The threaded end of the mounting
plate adapter should be facing the lampholder mounting plate.
Note: If the house lead wires are not long enough, it may be necessary to
attach 6˝ wire extensions.
Step 4: Screw the mounting plate adapter (G) into the lampholder mounting plate.
Note: Use the locknut to adjust and tighten the adapter to the mounting plate.
Step 5: Apply silicone caulk around the mounting plate adapter to ensure
a watertight seal.
Step 6: Mount the fixture to the mounting plate
adapter (G) using the 3 screws and nuts
provided (H) (Fig. 4). House supply wires
should be in the bottom area of the fixture
arm at this point.
Step 7: Make wiring connections inside the fixture arm as described in
"Wiring your fixture."
Wiring your fixture
Before continuing - turn off the power at the main fuse / breaker box. If the
supply wires coming from your house are solid, you can use the Quick-
connect™ wire system to attach your Cooper Lighting, LLC light fixture.
Note: Quick connectors can only be used with solid supply wires.
Step 1: Attach your ground supply wire to the fixture using the green
ground screw.
Step 2: Simply insert the black supply wire from your
house into the quick connector with the black
wire coming from the fixture (Fig. 5).
Step 3: Insert the white supply wire from your house
into the quick connector with the white wire
coming from the fixture (Fig. 5).
Step 4: Push both wires firmly into holes to insure that they are
seated properly and securely.
Proceed to "Attaching access cover and lens."
If the supply wires coming from your house are stranded:
For assistance, call 1-800-334-6871 or e-mail us at ConsumerProducts@cooperlighting.com
9/3/09 12:59 PM
House supply
wire
4
Page 4
Fig. 2
L
Fig. 3
Fig. 4
Fixture
wire
Fig. 5