Kobalt KR 124B-03 Manual De Instrucciones página 13

OPERATING INSTRUCTIONS
8. Variable-Speed Dial
Adjust the routing speed with the variable-speed
dial (B).
Turn the dial between "1" for the lowest speed and
"6" for the highest speed.
WARNING
• Never change the speed while the tool is
running. Failure to obey this caution could make
you lose control of the tool and result in serious
personal damage.
9. General Operations with the Compact Router
WARNING
• Before operating the tool, follow all safety instructions in this manual. Failure to do so could
result in serious personal injury.
• Always be alert and pay attention to the operation. Never operate the tool while fatigued.
NOTICE: Making test cuts is essential with most routing applications. A test cut yields information
about the set-up, the speed of the tool, the cutting depth, and how the cutter bit reacts to the
workpiece. Much of routing is a trial-and-error process of making various adjustments, followed by
test cuts, while learning all of the tool's operational abilities. To avoid ruining good material, make
the test cuts on scrap material.
When operating the tool, always hold it firmly with both hands to maintain proper control.
10. Routing with the Edge Guide
The edge guide can be used as an aid in routing
applications such as decorative edging, straight-
edge planing and trimming, grooving, dadoing, and
slotting.
To assemble the edge guide (M) onto fixed
base, simply align the edge-guide rods with the
protrusions on the fixed base (C), adjust to the
desired position, and lock them in place with the
edge-guide locking knobs (L).
Rotate the knob on the edge-guide to adjust to the
desired length.
Straight Routing
a. With the cutting depth set, place the tool on the edge of the workpiece, making sure that
the cutter does not contact the workpiece.
b. Turn the tool ON and allow it to attain full speed.
c. To begin the cut, gradually feed the cutter bit into the edge of the workpiece.
8
B
10
Knob
13
L
M