Kobalt KR 124B-03 Manual De Instrucciones página 15

OPERATING INSTRUCTIONS
Circular Routing with the Edge Guide
For circular work, assemble the edge guide (M) as
shown.
The minimum and maximum radii of circles to be
cut (distance between the center of circle and the
center of bit) are 74 mm (2 15/16ʺ) ~ 224 mm
(8-11/16ʺ), respectively.
Align the center hole in the edge guide with the
center of the circle to be cut. Drive a nail less than
6 mm (1/4ʺ) in diameter into the center hole to
secure the edge guide. Pivot the tool clockwise
around the nail.
11. Internal Routing
a. With the cutting depth set, tilt the tool and place
it on the workpiece, with only the leading edge
of the sub-base (J) contacting the workpiece.
b. Turn on the tool and allow it to attain full speed,
being careful not to allow the cutter bit to
contact the workpiece.
c. To begin the cut, gradually feed the cutter bit
into the workpiece until the sub-base is level
with the workpiece, then move the router to
make the cut.
d. When the cut is completed, turn off the tool and
allow the cutter bit to come to a complete stop
before removing it from the workpiece.
e. Remove battery pack and place the tool upside
down on the worktable and inspect the finished cut.
WARNING
• Always clamp the workpiece securely and keep a firm grip on the fixed base with both hands
at all times. Failure to do so could result in loss of control, causing possibly serious personal
injury
10d
Center hole
11
15