Settings; Channel Selection - Sony WRR-855A Manual De Instrucciones

Settings

Channel Selection

Notes
Take the following precautions to prevent interference and
noise.
• Do not simultaneously use two or more microphones and
transmitters that are set to the same channel.
• When using two or more tuners simultaneously, always set
the tuners that use the same groups (other than group 00) to
different channels in that group.
• The reception antennas and transmitter should be used at
least 3 meters away from each other.
Operations
2
4
1
3,5
S
IN G
M U T
E R O N
P O W
O F F E D
S I Z
8 5 5
T H E
R R -
S Y N
T W
U H F
U N I
E R
T U N
1
Turn the POWER switch ON.
On the WRR-855A, the "HELLO" message appears on
the display, then it changes to the tuner status indication
shown before the tuner was previously turned off.
On the WRR-855B, the version number of your tuner (for
example "U66") appears, then it changes to the tuner
status indication shown before the tuner was previously
turned off.
Note
POWER switch operation should be performed after
disconnecting the input from connected equipment, as
noise will be heard if the switch is turned ON or OFF
beforehand.
2
Press and hold the GP button down for more than one
second.
The tuner goes to the group selection mode and the group
number flashes.
Group
selection mode
3
Press the + or – button to select the group.
Pressing the + button cyclically changes the groups in
(Continued)
9
(GB)