Noise/Vibration Information; Declaration Of Conformity - Wurth Master ISS 45-M automatic Instrucciones Para El Manejo

ISS 45.book Seite 15 Montag, 12. Februar 2007 10:39 10
If a fault occurs (e.g. a torn filter), the unit must be immediately switched off. The fault must be remedied
before restarting.
Fault
The suction turbine does not
run
The suction turbine switches
off
The suction turbine does not
restart following
emptying of the container
The suction power
decreases
Dust is ejected during vacu-
uming
Automatic cut-out (wet vac-
uuming) defective
Filter cleaning system
switches on and off continu-
ously

Noise/Vibration Information

Measured values determined
EN 60 704-2-1.
Typically the A-weighted sound pressure level of the
tool is 67 dB (A).
Warranty
For this Würth machine, we provide a warranty in ac-
cordance with statutory/country-specific regulations
from the date of purchase (proof of purchase by invoice
or delivery note). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or im-
proper handling is excluded from the warranty.
Claims can be accepted only when the machine is pre-
sented undisassembled to a Würth branch office or a
Würth field service employee.
Trouble Shooting
Corrective measure
Check the cable, plug, fuse and socket, clean the electrodes.
Switch the unit on.
Empty the container.
Switch the unit off and wait for 5 s, switch it on again after 5 s.
Clean the electrodes as well as the space between them.
Remove possible clog-ups or obstructions from suction nozzle, extension wand,, suc-
tion hose or flat pleated filter.
Replace the paper filter bag.
Dedust the flat pleated filter: Actuate the filter cleaning system.
Engage the filter cover properly.
Replace the flat pleated filter.
Check the proper mounting position of the flat pleated filter.
Replace the flat pleated filter.
Clean the electrodes as well as the space between them.
Constantly check the filling level when working with an electrical non-conductive fluid.
Check if filter cleaning system is properly switched on or off
according to
Subject to change without notice

Declaration of Conformity

We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
EN 60 335-1, EN 60 335-2-69,
EN 55 014-2, EN 61 000-3-2, EN 61 000-3-3 ac-
cording to the provisions of the directives 98/37/EC,
73/23/EEC (changed by 93/68/EEC), 89/336/EEC
(changed by 91/263/EEC, 92/31/EEC, 93/68/EEC).
06
Adolf Würth GmbH & Co. KG
P. Zürn
EN 55 014-1,
R. Bauer
15