Publicidad
Idiomas disponibles
Idiomas disponibles
CHARACTERISTICS OF TOOL
Jigsaw is a power tool designed for cutting wood surfaces and surfaces made of wood-based materials, plates made of polyethyl-
ene or polypropylene and soft metals, by using the appropriately selected blades to the type of material. The tool allows for easy
cutting of the workpiece surfaces with possibility to adjust the cutting angle. Correct, reliable, and safe operation of the device is
dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any injury and damage, which are resulting from failure to comply with its designation, lack of compliance with the safety
regulations and instructions of this manual, the supplier is not responsible. The tool misuse causes also the loss of user's rights
to the guarantee, as well as warranty.
EQUIPMENT
There should be in the factory packaging:
- jigsaw
- blade cover
- blade
- wrench
- guide
TECHNICAL PARAMETERS
Parameter
Catalog number
Mains voltage
Frequency
Rated power
Rotations
Insulation class
Cutting thickness max.
- wood
- polyethylene / polypropylene
- soft metals
Weight
Noise level:
- pressure (iddle run)
- power (iddle run)
Vibrations (wood / metal cutting)
Degree of protection
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodified plug which fits the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
O R I G I N A L
GB
Unit
[V~]
[Hz]
[W]
[min
-1
]
[mm]
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s
]
2
I N S T R U C T I O N S
Value
79474
230 - 240
50
650
0 - 3000
II
65
12
8
1.9
87.4 ± 3.0
98.4 ± 3.0
6.4 ± 1.5 / 6.9 ± 1.5
IPX0
13
Publicidad
