Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
STANDARD WALL INSTALLATION
• Figure 1. Remove plaster guard from valve. Push CAP (1)
over VALVE CARTRIDGE (2) until seated against stop.
• Figure 2. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
THIN WALL INSTALLATION
• Figure 1a. Push CAP (1) over VALVE CARTRIDGE (2) until
seated against stop.
• Figure 2a. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
PLASTER
GUARD
Figure 1.
Figure 1a.
2
INSTALL TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
• Remove pipe cap and plug from shower and tub
rough piping.
• Slip DECORATIVE PLATE (5), then slip TUB SPOUT (1)
onto tub nipple and tighten with 2.5 mm Hex Wrench.
CAUTION: Protect finish on TUB SPOUT when
installing.
• Install SHOWER ESCUTCHEON (2) onto SHOWER
ARM (3). Apply sealant or Teflon tape to threads on
both ends of SHOWER ARM (3) and thread longer
leg of SHOWER ARM (3) into shower elbow.
• Thread SHOWER HEAD (4) onto SHOWER ARM (3).
CAUTION: Protect finish on SHOWER HEAD and
ARM when installing.
3
HANDLE INSTALLATION
• Install HANDLE (1) by pushing it onto CARTRIDGE STEM (2)
and tightening SET SCREW (3) from below with 2.5 mm
Hex Wrench supplied.
1
2
2
1
4
CAUTION
- 2 -
1
Figure 2.
1
Figure 2a.
Protect finish on SHOWER HEAD
and TUB SPOUT when installing.
TUB FILLER
NIPPLE
1 -
1 /
3
4
3
4
2
SHR.
ELBOW
PIPE
PLUG
3
PIPE
CAP
5
2 "
R E
F .
2.5 MM HEX
WRENCH
2
3
1
2.5MM HEX
WRENCH
M965966 Rev. 1.2 (10/19)
4
1
Publicidad
Tabla de contenido
