Kohler K-3437 Guia De Instalacion página 8

Fill Valve Nut
Comp. Washer
Supply Shank
Seal Washer
Tubing
Coupling
Comp. Nut
Nut
Comp. Nut
Supply Shut-Off
Valve
Ferrule
Supply Shut-Off Valve Connection
5. Complete the Installation
Remove the Packing Material
NOTE: Do not remove the pump hose clamps.
Cut the wire tie holding the pump to the back wall of the toilet.
Discard this wire.
If the pump has shifted during shipping or installation, reposition
it so it is not touching the back or side wall of the toilet.
Complete Connections
Connect the supply shut-off valve to the toilet supply shank.
Open the supply shut-off valve slowly to check for leaks. If the
connections have been properly assembled, a slight tightening of
the nuts should stop any leakage.
Plug the toilet electrical cord into a Class A Ground-Fault
Circuit-Interrupter (GFCI).
Adjust the tank water level to the proper marked waterline by
rotating the threaded rod clockwise to raise the water level or
counterclockwise to lower the water level.
Carefully set the cover onto the tank.
1021801-2-A
Tubing
Coupling
Nut
Float
Ferrule
Waterline
8 Kohler Co.