LUND Rampage 8854 Instrucciones De Instalación página 2

Installation
1
Remove any Factory or aftermarket steps or rock rails present on the vehicle.
2
Start installation toward the front of the driver side of the vehicle and find the front threaded insert located in
between the first pair of holes along the pinch weld. See Figure 1
Select the Driver/left side Front Mounting Bracket. Attach the Bracket to the threaded insert using (1) 8mm
Hex Bolt, (1) 8mm Lock Washer and (1) 8mm Flat Washer. See Figure 2 Do not fully tighten hardware at
this time.
Figure 1
Left Front
3
Select the Driver/left side Front Support Bracket. Align the Bracket to the back of the pinch weld and to the
rear side of the Front Mounting Bracket. Attach the Support Bracket to the pinch weld using (2) 6mm Hex
Bolts, (4) 6 mm Flat Washers and (2) 6mm Nylon Lock Nuts. NOTE: Insert bolts from the outside of the
pinch weld and through the Bracket. Use (1) 10mm Hex Bolt, (2) 10mm Flat Washers and (1) 10mm Nylon
Lock Nut to secure the Support Bracket to the Mounting Bracket. See Figures 3 and 4. Do not fully tighten
hardware at this time.
Figure 3
Left Front
Figure 2
Figure 4
6mm Bolts,
Washers and
Nylock nuts
Left Front
10mm Bolt,
Washer and
Nylock nut