Operating Instructions - Kobalt SGY-AIR160TZ Manual Del Usuario

ASSEMBLY INSTRUCTIONS
4. Pour paint into the paint cup. Hold or adjust paint cup
so that paint can be easily added and controlled
once paint is inside cup. Secure paint cap lid
turning clockwise by hand (See Figure 4; Not all
accessories shown are included).

OPERATING INSTRUCTIONS

NOTE
Before using desired paint in the spray gun, spray a compatible thinner or solvent
through the gun to remove any contaminants and residues.
Thin paints properly in accordance with the paint manufacturer's instructions
before spraying.
Fill the paint cup (B1/B2) about 3/4 full and start the air compressor.
Set up a piece of cardboard or other scrap material to use as a target and adjust
for best spray pattern.
Test the consistency of the paint by making a few strokes on a cardboard target. If
paint still appears too thick, add a small amount of thinner. Do not exceed paint
manufacturer's thinning recommendations.
The paint sprayer will not properly spray unless
the fan direction is either horizontal or vertical.
1. Adjust the direction of fan to be either horizontal
or vertical as required by loosening the air cap
ring (D1/D2) 90 degrees. Hand tighten the air
cap ring (E1/E2) after adjustment (See Figure 1).
NOTE During normal use, the air ca
adjusted to be horizontal. This provides a vertical
fan-shaped pattern which gives maximum and
even material coverage as the gun is moved back
and forth parallel to the surface being finished.
WARNING
p
4
A
B
Clockwise
1
Air Cap
Air Cap Ring
D ( 1 D / ) 2 s i
8
Clockwise
A
Load paint
Load paint
B
Horizontal Fan
Vertical Fan