Publicidad
Idiomas disponibles
Idiomas disponibles
EN
LUBRICATING YOUR BEARINGS: You will need to take off your wheels to lubricate your wheel bearings. Insert 6mm
allen keys, in each axle head and turn them counter clock-wise. The wheels may need some encouragement to
slide out. Using a damp cloth wipe off any dirt or grime on your wheels and bearings. Using bicycle bearing oil, place
3 to 4 drops directly on the bearing covers and allow the oil to sink in. If the wheels do not spin freely after this you
may need to replace the bearings.
CLEANING YOUR SCOOTER: Never use alcohol or any strong cleaning agents to clean your scooter. Doing so may
damage paint or fragile materials. Warm water and a damp cloth should be enough. Avoid putting water directly on
the grip tape and never submerge your scooter in water.
Limited Warranty:
The product applies to the minimum statutory warranty of the particular country on material-
and production defects. During this time, it is an in NKD's discretion if products are repaired or replaced. This
warranty is not covering defects originated in improperly use such as incorrect assembling, careless handling,
modified in any way, or common wear out.
Warranty adjustments:
absolutely necessary to keep your receipt. In case of warranty claim NKD™ or the responsible dealer is deciding if
the product will be repaired or replaced.
Scooter assembly
(Ensure all wrapping and packing materials are taken off your scooter before you start)
Slide the handlebars onto the fork tube (Figure 1-2), ensure the fork and bars are lined up before doing so. Avoid
twisting/turning the bars as you slide it down. Doing so may loosen the compression. Ensure both the bars and the
clamp are touching the top of the headset.
1
/
S
E
/
N
O
2
When you are satisfied that your front wheel and your handle bars are in line. Use your 6mm allen key, to tighten
the bolts from the bottom up (Figure 3). Do this by turning the allen key in a clockwise rotation. Repeat this action
until the 2-4 bolts are tightened securely. Take care not to overtighten your clamp bolts. Failure to tighten or install
properly may result in loss of control and injury. If you have trouble understanding these instructions, seek
assistance from a qualified mechanic.
5
Warranty claim is solely coming into effective with proof of purchase. Due to that it is
2
K
/
S
E
/
N
O
2
3
K
/
S
E
/
N
O
2
Publicidad
