Technical Specification - Velleman CAMSCC15 Manual Del Usuario

manual for the pin layout. Replacing the connector should
be done by a qualified technician.
• To adjust the focus of the camera, loose the lock screw
[B] on the flange adjustment ring [A], turn the ring until
the desired focus is reached and retighten the lock screw
[B]. Adjusting the focus should be done by a qualified
technician.
7.

Technical Specification

pick-up element
number of pixels
Resolution
min. illumination
S/N ratio
electronic shutter
iris mode
video output
lens mounting
BLC
white balance
sharpness
power supply
dimensions
weight
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulted from (incorrect) use of this device.
For more info concerning this product, please visit our
website www.velleman.eu.
The information in this manual is subject to change without
prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by
Velleman Components nv. All worldwide rights reserved. No part of this manual
may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder
19/02/2009
CAMSCC15
1/3" HR colour CCD image sensor
753 (H) x 582 (V) - PAL
500 TV lines
0.11 lux / F2 .0
> 48dB (AGC off)
1/50 to 1/100.000 sec
AES / VD / DD selectable
1Vpp, 75 ohms
CS or C mount
on/off
ATW/HOLD selectable
soft/sharp
12VDC ± 10% / 100mA regulated
(use PS1205R, not incl.)
117 x 60 x 50mm
250g
5
®
©Velleman Components nv