Recording; Setting Input Destinations; Adjusting The Input Level; Using The Limiter - Tascam DR-701D Manual Del Usuario

This enables selection of a different item. Turn
the DATA dial to select an item to be set.
6. Repeat step 3 to 6 as necessary to set other items.
7. Press the MENU button to return to the Home
Screen.

Recording

Setting input destinations

Connect external mics to the EXT IN 1/2, IN 1, IN
1.
2, IN 3 and/or IN 4 jacks.
2. Select the item on the
SEL
"Basic operation procedures" on page 11.)
3. Select a channel and set its input destination.
Item Option
EXT IN
(default)
CH1 /CH2
IN 1 -2
INT
(default)
CH3/CH4
IN 3-4
When finished, press the MENU button to return
4.
to the Home Screen.

Adjusting the input level

1. Select the item on the
GAIN
"Basic operation procedures" on page 11.)
2. Select the channel with the input level that you
want to adjust and set the mic input gain.
Options: ,
LINE LOW
When finished, press the MENU button to return
3.
to the Home Screen.
Turn the DATA dial to switch the Home Screen to
4.
trim display mode.
Use the 1–4 knobs to adjust the input levels.
5.
Guidelines are shown at −20dB and −12dB.
Set levels so that they average around −20 dB
and have a maximum level of −12 dB.
12
TASCAM DR-701D
page. (See
INPUT
Meaning
Input from EXT IN 1/2
jack
Input from IN 1/IN 2 jacks
Input from built-in mic
Input from IN 3/IN 4 jacks
page. (See
INPUT
(default), , ,
MID HI HI +
Set the input levels so that the 1–4 knob PEAK
indicators do not light. If they do, the sound will
distort.

Using the limiter

When the limiter is on, the mic input gain will be
adjusted automatically according to the input level
to set the recording level so that distortion does not
occur even when loud sounds are input.
1. Select the item on the
LIM.
page. (See "Basic operation procedures" on page
11.)
2. Select the channel that will use the limiter
function, and set the limiter function to use
during mic input.
Option Meaning
OFF
Limiter off
(default value)
Limiter on
ON
Three-band limiter on
3B
Limiter on (channel link)
LINK
Three-band limiter on (channel
3BAND
link)
When finished, press the MENU button to return
3.
to the Home Screen.
Setting the automatic level control
(ALC) function
When ALC is on, the input level will be automatically
adjusted in response to the input sound.
1. Select the item on the
AUTO
page. (See "Basic operation procedures" on page
11.)
2. Select the channel that will use the ALC function,
and turn the ALC function on/off.
Options: (default),
OFF
When finished, press the MENU button to return
3.
to the Home Screen.
LEVEL CONTROL
LEVEL CONTROL
ON