Charging The Device - Würth WPS 12-900 Traducción Del Manual De Instrucciones De Servicio Original

Remote start of a vehicle engine
Note
Charge the device for 12 hours before
ignition key.
Check whether the operating switch
to "0".
First, connect the red positive terminal to the posi-
tive terminal of the vehicle battery.
Then connect the black clamp to a suitable earth-
ing point on the vehicle body.
Note
Optionally, you can connect the black
terminal also to the negative terminal of
the vehicle battery.
Turn the operating switch
(on WPS 1224-900 depending on on-board
voltage).
The device is switched on.
Start the vehicle engine.
Turn the operating switch to "0".
First, remove the black clamp from the ground
point of the vehicle, then the red clamp.
Connect the Power Start for at least 12 hours to
is set the charger.
to 12V" or "24V"
If the engine does not start within
3-8 seconds, stop the start-up procedure.
Wait at least 1 minute and try again.

Charging the device

Power Start
Is lit red The charger is not properly
connected to the device, the
charging will not start.