Use Instructions; Timer Function - M Confort GLASS Manual De Usuario

6. USE INSTRUCTIONS

1. Conect the unit to the mains.
2. Set the rocker switch to the position II: The heater starts to work.
Remote control cannot operate the heater at this stage.
3. Set the rocker switch to the position O: The heater is power off.
4. Set the rocker switch to the position I, the heater will enter Standby
mode. This symbol will be displayed (--).
power level (P3). Press "LOW" (P1), "MID" (P2), "HIGH" (P3) to change the the
level of the heating.
4.TIMER FUNCTION: press "1H" button to set timer function from 1 to 13h. Time
selected will be displayed in the heater. Timer function makes the heater return
to standby mode after the time slected.
Once you start timer function, heater will diisplay the remaining time alternately
with the working power. For examplo, if 13h timer is triggered, display will show
"11" after 2 hours running.
Deactivate or reprogram the timer: If the timer is activated, pressing the same
button at the second time will reprogram or disable the timer.
Example 1. After activating the 13 hours timer by press the button "1" "2" "4" "6", pressing
the button"1" afterwards will reprogram the timer to (13-1) = 12 hours, Pressing the button"2"
button afterwards, the timer will be reprogrammed to (13-2) = 11 hours. Pressing several other
keys in sequence, the timer can be reset to 0, the heater goes into Standby mode and the
symbol "- - "will be flashing.
Example 2, a 6 hours timer is set by pressing button "2" "4". Press the button "2", the timer is
set to 6-2 = 4 hours, Press the button "4" straight afterwards, the timer is set to 0, the heater
goes into standby mode and the symbol "- -" will be flashing.
ATENTTION: There is a built-in safety feature that will automatically trigger the
heater to go into standby mode after 8 hours of continuous operation, if the
timer is not triggered.
5. Point the remote control to the receiver. Press
the key "ON", the unit starts heating at high
09
Attention: