At The End Of The Work; Daily Maintenance; Replacing The Filter - Collection Bag; Cleaning Accessories - Fimar FA15+ Manual De Uso Y Mantenimiento

At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Take the appliance to the place where it is maintained and
carry out all the procedures listed in the chapter
MAINTENANCE".
2. Take the appliance to the designated machine storage place.
3. Do what is required to make sure the appliance is in a safe
condition (read the section "APPLIANCE
REPLACING THE FILTER – COLLECTION BAG
To replace the filter - collection bag, proceed as follows:
1. Do what is required to make sure the appliance is in a safe
condition (read the section "APPLIANCE
2. Raise the vacuum tank (1) lid using the handle (2) on the front of
the collection tank, turn the handle clockwise.
3. Using the handle (3), in the vacuum tank lid, remove the vacuum
tank lid from the collection tank (rotating it and shifting it as
indicated in the figure). Put the vacuum tank lid gently on the floor.
4. Remove the filter - collection bag from inside the collection tank
being careful not to rip it. If the bag is made of paper, dispose of it
properly, but if it is made of fabric just empty it.
1
2
1

CLEANING ACCESSORIES

Accessories in a good condition guarantee improved suction and
cleaning of the floor, as well as a longer vacuum motor life. To clean
the accessories, proceed as follows:
1. Take the machine to the maintenance area.
2. Do what is required to make sure the appliance is in a safe
condition (read the section "APPLIANCE
2
1

AT THE END OF THE WORK

"DAILY
SAFETY").

DAILY MAINTENANCE

PERFORM ALL MAINTENANCE OPERATIONS IN SEQUENCE
SAFETY").
3
2
SAFETY").
3
4. Insert the vacuum hose fastening clip in the support at the front of
the handle in the collection tank lid.
ATTENTION: Park the appliance in an enclosed place, on a
flat surface; near the appliance there must be no objects that
could either damage it, or be damaged through contact with it.
5. Do what is required to replace the filter - collection bag (read the
section "INSERTING THE FILTER - COLLECTION
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
ATTENTION: The place this operation is carried out should comply
with current environmental protection regulations.
3. Remove all the accessories from the vacuum hose and clean
them with a damp cloth.
4. Remove the vacuum hose (1) from the vacuum nozzle (2) on the
collection tank, before pulling the vacuum hose press the button
(3) for releasing the catch. Clean it with a damp cloth.
5. Repeat the operations in reverse order to reassemble all the
parts.
28
BAG").