Individual Settings - Palmer MONICON XL Manual De Usuario

DIM ATTENUATION
20
The DIM function allows you to lower the output signals of the BALANCED MONITOR OUTPUTS 1 to 3 line
outputs and the 1 and 2 (MAIN signal) headphone outputs by the value set on the ATTENUATION control,
without affecting the CUE signals. For example, you can have a conversation in the control room at a
low volume without disturbing an ongoing recording. Press the DIM button once to activate the function
and then press it again briefly to deactivate the function. The button illuminates when the DIM function is
activated.
HEADPHONE OUTPUTS 1 AND 2
21
Headphone outputs with 0.25 inch jack sockets. Use the CUE/MAIN switch on the desired headphone
output (switched-down position = CUE signal, not in the switched-down position = MAIN signal) to select
the signal source and adjust the volume using the corresponding LEVEL level control. To prevent damage to
equipment as well as hearing damage, turn down the volume to minimum before connecting and putting
on headphones, and then only gently raise the volume, keeping the levels of the various signal sources at a
similar level to avoid sudden jumps in volume when switching sources. The signals are each tapped before
the CUE and MAIN volume controls (PFL).
PIN ASSIGNMENT
Balanced jack
+ -
GND

INDIVIDUAL SETTINGS

Certain functions can be adjusted and their settings saved (see table below) to help you work the way you
want. Information about this is also printed in English on the bottom of the device.
Hold down button while switching
on Monicon XL
CUE SOURCE "IN 1"
CUE SOURCE "IN 2"
CUE SOURCE "IN 3"
INPUT SELECT "IN 1"
INPUT SELECT "IN 2"
OUTPUT SELECT "OUT 1"
OUTPUT SELECT "OUT 2"
OUTPUT SELECT "OUT 3"
"MUTE"
"TALK"
"MONO"
Unbalanced jack
+ -
/ GND
Mode of operation for corresponding display and operating controls:
Adjustment of the LEFT/RIGHT level indicator: Maximum display
"0 dB" (red LED) corresponds to +4 dBu input signal level
Adjustment of the LEFT/RIGHT level indicator: Maximum display
"0 dB" (red LED) corresponds to +10 dBu input signal level
Adjustment of the LEFT/RIGHT level indicator: Maximum display
"0 dB" (red LED) corresponds to +18 dBu input signal level
Multi mode: All INPUT SELECT inputs can be activated at the same time
Individual mode: Only one INPUT SELECT input can be activated at
a time
Multi mode: All OUTPUT SELECT outputs can be activated at the
same time
Individual mode: Only one OUTPUT SELECT output
can be activated at a time
Combined mode: OUT 3 activates and deactivates independently
OUT 1 and OUT 2 can be selectively activated
Switching the MUTE button's mode of operation from switch (latch-
ing) to button (momentary)
Switching the TALK button's mode of operation from switch (latching)
to button (momentary)
Reset to factory default
Headphone jack
L R GND
Cinch socket
+ -
/ GND
11