Defect Codes; Auto Scale Removal Function - Klarstein LUMINANCE STEAM Manual De Instrucciones

Defect Codes

Below defect codes may occur during steam functions :
E-06: 1-Water tank is not close well.
E-05: water system abnormal, need to contact for Engineer to check, below is the
possibilities.
1-The water sensor is abnormal.
2-The water pipe is abnormal.
3-The water pump is abnormal.
4-The water tank is abnormal.

Auto Scale Removal Function

For best cleaning results, we recommend that you use detergent sodium citrate, which
were randomly for descaling steam microwave oven. Follow the manufacturer's
instructions on the packaging. It is suggested that descaling function should be used
after the steam function has been run for 20 hours.
1. Power up the system, remove the water tank, inject 1000 ml of fresh water into the
water tank, adding a pack of descaling agent.
2. Push the water tank into the appropriate location of the appliance.
3. In standby mode,
d01, default weight 0.10, corresponding cooking time and " Kg ""Min" light up.
4. Press repeatedly, when" CLE " indicator lighten, it means to enter Scale
Removal function. "Min" and default time "20:00 "lighten, tank icon show the
current water level ( Water, lack of water, full of water ), other icons disappear.
5. Press to start the program.
6. Stay whole 1 minute after the program has finished, take out the water tank and
pour the water in the tank. Thoroughly clean the water tank.
7. Replace the fresh water, repeat steps 3 to 6.
Note: the descaling process shall not be shut down. If the descaling process shut down
before the end, the entire program must be started from step 3.
button, the display lights, screen displays default mode
EN
71