Adjusting The Monitor Angle - Sony XAV-7W Manual De Instrucciones

Note
Do not move the monitor by hand.
Notes
• When the monitor is closed, MENU,
LIST, and ENTER on the card remote
commander cannot be used.
• If movement of the monitor during
opening or closing has been impeded
by the gear shift lever or another
obstacle, see "If movement of the
monitor has been impeded during the
monitor setting" (page 45).
• If OPEN/CLOSE was pressed while
the monitor was opening or closing,
the monitor may not stop at the
original angle. In such a case, press
ANGLE –/+ to adjust the angle.
Tip
If you have pressed OFF when opening
up the monitor, you can press SOURCE
to turn the picture on again.
* Warning when installing in a car
without an ACC (accessory) position
on the ignition key
After turning off the ignition, be sure to
press OFF on the unit for 2 seconds to
turn off the clock display.
Otherwise, the clock display does not
turn off and this causes battery drain.
To turn on the unit when it is turned
off, press SOURCE on the unit. (You
cannot turn on the unit with the card
remote commander.)

Adjusting the monitor angle

You can adjust the angle of the monitor for best viewing.
Press ANGLE –/+ repeatedly.
The buttons adjust monitor position in discrete steps.
+ button: Monitor is tilted backward.
– button: Monitor is tilted forward.
The adjustment is memorized, and the monitor will move
to the same angle the next time it is opened up again after
having been closed.
Closing the monitor
Press OPEN/CLOSE.
The monitor retracts into the unit, and you can use only the
audio functions of the unit.
OPEN/CLOSE
Shutting down
• If you press OFF on the card remote commander while
the monitor is opened up, the sound is turned off, and
the unit switches to the standby mode, in which only the
clock indication is shown.
• If you set the ignition key of the car to OFF, power to the
unit is automatically turned off.*
ANGLE –/+
OFF
7