Menu Navigation - Ideal SureTest 61-164 Manual De Instrucciones

circuit interrupter (AFCI) devices to ensure that AFCI breakers protecting the circuit have been
installed correctly. This test disrupts the electrical supply if a functional AFCI is present. This tool
also checks for a shared neutral condition that leads to AFCI nuisance tripping.
To maintain stated accuracies during repeated use, allow 20 seconds between insertions to
adequately dissipate any heat buildup during the load testing.
WARNING: Do not use on outputs from UPS systems, light dimmers or square
wave generating equipment as damage to the analyzer will occur.
SureTest Circuit Analyzer
1. Menu Structure
2. Navigation Buttons
3. GFCI Test Button
4. AFCI Test Button

Menu Navigation

The microprocessor's top priorities are to take live measurements and then analyze the data.
Hence, the microchip occasionally will not recognize the keypad buttons being rapidly depressed,
while it's executing these routines. To avoid this issue, hold down the keypad button each time
until the menu changes.
The measurements taken by the SureTest are broken into five main menus positioned down the
left side of the display: Wiring Configuration (•••), Voltage (V), Voltage Drop (V
(A), and Impedance (Z). To navigate to each of the main menus, use the down arrow button ( ).
The Wiring Configuration (•••) screen indicates correct wiring, reverse polarity, hot/
ground reversal and no ground conditions by sequencing the three balls. The label on the back of
the product explains the wiring sequence indications.
The Voltage (V) menu displays the True RMS line voltage in real-time. This main menu has a
sub-menu positioned horizontally at the bottom of the screen that displays the line voltage
(RMS HN), ground-to-neutral voltage (RMS GN), Peak voltage (Peak), and Frequency (Hz). To
navigate through the submenu, use the side arrow button (
The Voltage Drop (V
the resultant loaded voltage (V
percent voltage drop and loaded voltage with 20 amp and 12 amp loads. To navigate through the
submenu, use the side arrow button (
1
2
3
4
) screen dual displays percent voltage drop with a 15 amp load along with
D
). This main menu has a submenu, which also displays the
L
).
2
D
) .
), Amperage