Choosing The Method To Connect: Via Wireless Lan Or Other Method; Connecting Via A Wired Lan (Mf244Dw/Mf232W Only); Connecting Via A Usb Cable; Checking Before The Setup - Canon imageCLASS MF244dw Manual Del Usuario

Choosing the Method to Connect:
Via Wireless LAN or Other Method
●
MF244dw/MF232w
Use wireless LAN to
connect to network?
(Can config. later.)
Yes No
There is a button.
Start from step 4 of "Push Button Mode" (P.11).
Yes
There is no button.
Start from step 4 of "Setting the Access Point Manually"
(P.12).
Connect to the computer via a wired LAN
Proceed to "Connecting via a Wired LAN
(MF244dw/MF232w Only)" (P.10).
Connect to the computer via a USB cable
No
Proceed to "Connecting via a USB Cable" (P.10).
Connect to the computer via a wireless LAN later
Proceed to "Connecting via a Wireless LAN
(MF244dw/MF232w Only)" (P.11).
●
MF241d
Connect to the computer via a USB cable
Proceed to "Connecting via a USB Cable" (P.10).
Connecting via a Wired LAN
(MF244dw/MF232w Only)

Checking Before the Setup

Internet
En
Are the computer and the router (or hub) properly
connected using a LAN cable?
For more information, see the instruction manual for the
network device you are using, or contact the networking
device manufacturer.
Have the network settings on the computer been
completed?
If the computer is not properly confi gured, you may not be
able to use the wired LAN connection even after completing
the following settings.
10
Current Time Set.
Must rechg. battery
for 24 hours to save
time settings. After
turning main power
Router
or
hub
LAN cable
NOTE
• You cannot connect both the wired LAN and wireless
LAN at the same time. In addition, the machine is set to
the "Wired LAN" by default.
• When you connect to a network environment that is not
security protected, your personal information could be
disclosed to third parties. Please use caution.
• If you connect through a LAN in the offi ce, contact your
network administrator.
Connecting via a Wired LAN
1
Connect the LAN cable.
The IP address will be automatically confi gured in 2
minutes. If you want to set the IP address manually, see
the following items.
User's Guide "Network" ▶ "Connecting to a Network" ▶
"Setting IP Addresses"
2
Install the driver and software using the provided
DVD-ROM.
See "For details on the installation procedures:" (P.13).
Proceed to "Setting a Paper Size and Type" (P.13).

Connecting via a USB Cable

Install the Driver and Software
Install the driver and software on the provided DVD-ROM.
See "For details on the installation procedures:" (P.13).
Proceed to "Setting a Paper Size and Type" (P.13).
NOTE
• If you connected the USB cable before installing, fi rst
remove the USB cable and then re-install.