Canon imageCLASS MF244dw Manual Del Usuario página 12

7
Press and hold* the button until the lamp lights or
blinks.
You should press the WPS button within 2 minutes after
you select <Yes> in step 6.
* The time that you should hold the button may vary depending
on the router you are using.
8
Wait approximately 2 minutes after the connection.
IP address is set during this period of time.
When an error message appears:
Press to close the screen, check whether or not the
network key is correct, and then retry the settings. If the
access point cannot be detected even after retrying,
see the following.
User's Guide "When an Error Message Appears"
When checking the network connection:
You can check if the machine is properly connected to
the network by using a computer that is connected to the
network.
User's Guide "Viewing Network Settings"
To set IP address manually:
User's Guide "Connecting to a Wireless LAN"
Setting the Access Point Manually
1
Check SSID or Network Key for a Wireless LAN
Router/Access Point.
• Check the label on the Wireless LAN router.
• You can check the SSID or the network key using "Canon
MF / LBP Wireless Setup Assistant, " which is included in
the DVD-ROM supplied with the machine.
En
12
SampleABCD WEP 01234567890123456789ABCDEF
SampleEFGHIJ WPA-PSK 543210EDCBA
SampleK WPA2-PSK 1234ABCD
If the information of the wireless LAN router is not
displayed, click the [Refresh] button. If the information is
not displayed when you click the [Refresh] button, check
if the computer settings for a wireless LAN router (access
point) are complete.
2
Write down the name of SSID and network key
displayed in step 1. When multiple access points are
displayed, write all SSIDs that are displayed.
SSID
It is sometimes written as name of network, or name of
access point. If there are multiple SSIDs, please write down
all.
Network Key
It is sometimes written as PIN, WEP key, WPA/WPA2
passphrase, PSK or preshared key.
3
Press .
4
Select <Network Settings>, and then press
5
Select <Wireless LAN Settings>, and then press
If a screen appears asking whether to enable the wireless
LAN, select <Yes>, and then press
6
Read the message that is displayed, and then press
.
7
Select <SSID Settings>, and then press
.
.
.
.