Onkyo TX-RZ1100 Manual Del Usuario página 2

EN FR ES
5. Use the or buttons on the remote controller to display "Connect Device"
and press ENTER. This will allow you to see all the Sonos devices on the
same network as the unit. Select the Sonos Connect that is connected to your
unit and press ENTER.
(Note)
• Products other than Sonos Connect (products without output terminals such
as Play:3) are also displayed in the list and are selectable. In these cases,
input switches when play starts on the Sonos product, but the audio is not
output. Select the room name for the connected Sonos Connect.
• The list of Sonos products can show up to 32 units. If you cannot find the
Sonos Connect you want to link with, return to the previous screen, turn off
the products you do not want to link, then try again.
6. Use the or buttons on the remote controller to display "Out Zone:" and
then use the or buttons to select the Zone where you want to hear the
music. The unit automatically switches to play in the main room (the room
where this unit is), another room (Zone 2) or M/Z2 (the main room and Zone
2), according to play on Sonos Connect. Some units may have additional Zone
outputs.
7. Press the (SETUP) button on the remote controller to exit the setup menu.
8. Setup is now complete and you are ready to use your equipment.
• The power on linking depends on the network standby function of this unit.
For details, refer to this unit's instruction manual.
Now the fun part - listening to Sonos on
your Unit
1. Using your Sonos App select the music you want to listen to and send it to the
room (or group) where your unit is located. We recommend naming your unit
/ Sonos Connect combination a friendly name like TV Room or Living Room
where the equipment is located.
2. Just like your other Sonos speakers and gear that you are familiar with you
can group your unit with other speakers or listen to it by itself.
(Note)
If the input on your unit does not change automatically when play starts, try
stopping play, then starting it again.
IT DE NL SV JP
繁中
Setting the Preset Volume
You can set the volume that Sonos Connect will be played at beforehand. The
volume set will be used only when using Sonos Connect.
1. Press (SETUP) button on the remote controller to display the setup menu.
2. Press the or buttons on the remote controller to display "WorksSONOS".
• If "WorksSONOS" is not displayed, select "Hardware" and press ENTER,
then press the or buttons on the remote controller to display
"WorksSONOS".
3. Select "WorksSONOS", and press ENTER.
4. Press the or buttons on the remote controller to select "Preset Volume"
and press ENTER.
5. Press the or buttons on the remote controller to display the main room
(where this unit is located) or another room (Zone 2 or Zone 3, for example),
then press or to set the volume.
• Select "Last" to return to the initial setting.
6. Press (SETUP) button on the remote controller to exit the setup menu.