Reset Button - sanindusa TUBE 531738111 Instrucciones De Montaje Y Manutención

//MAINTENANCE
Temporary off function:
This function is ideal to perform any kind of activity in front of the sensor without
operating the system (for example, cleaning).
The flush valve will remain shut for 1 minute when this button is pressed once.
To cancel this function and to return to normal operation press the On/Off
button again or wait 1 minute.

Reset button:

This function restores all the factory settings except for the sensor range. If
required, press the Reset button and without releasing it, press the
(+) button once.
Note: To enter the self adjusting mode, use the ADJ button. To change the sensor
range, use the RANGE button.
Filter cleaning instructions
This mixer is provided with one/two stainless steel filter(s) preventing foreign particles to enter
the lines. If the water flow has decreased, this may be because the filter(s) is (are) clogged. The
filter(s) can be cleaned as follows:
531738111
Electronic tap without box
1 – Shut-off the water shut off valve.
2 – Disconnect the water supply pipe from the adaptator and disassemble the filter from it.
3 – Wash the filter under running water.
4 – Reassemble the parts.
5 – Restore the incoming water supply.
6 – Make sure that there is no water leakage.