Crosley CR2405D Manual De Instrucciones página 10

English
split the tracks before the recording process is finished by using one of the two
methods below:
Manual Track Split (recommended)
When recording, pay attention to the end of each song. Usually there is a
brief silence between songs, when this happens, press the MANUAL button
once. The recorded music will be split into its own sound track and a new
sound track is created for the rest of the music. This is the recommended way
of splitting sound tracks for highest split accuracy.
Auto Track Split
Before pressing the CD Record button in step 3 from the above section,
press the AUTO button on either the front panel or the remote control. The
display will toggle the decibel level (-20, -30 and -40) which is required to split
the sound tracks. For example, if -40 is selected, new tracks will be created
automatically whenever the recording level falls below -40db for 2 seconds or
more.
Depending on the specific music that you are playing and the decibel level
selected, this split method might not be as accurate. This is because some
music might be playing at a volume lower than the decibel level selected for
over 2 seconds or the silence period between sounds is still too high or
shorter than 2 seconds. In these cases, new tracks would be created
incorrectly.
However, you could still manually split a track under the auto track split mode.
Recording Cassettes to a Disc
1. Press the TAPE button to switch to Cassette mode.
2. Load a compatible blank disc into the CD tray.
3. Press the CD Record button to start the recording mode. "REC" and
will show on the top left corner of the LCD display.
4. Insert the prerecorded cassette tape into the cassette slot.
5. Start the recording process by following the instructions 5-14 as mentioned in
the vinyl recording section.
Erase the Rewritable Disc
The CD-RW could be erased and recorded if the last recording is not satisfying:
1. Press the CD button to select CD mode.
2. Load the CD-RW which needs to be erased into the tray.
3. If the disc is finalized, it needs to be un-finalized first. Press the Erase button,
"UNFIN-D" will show on the LCD display. Press the Play/Pause button to
confirm the un-finalization process.
4. Press the Erase button again, the LCD display will show "ER" and the last
track number recorded on the disc. Press the Play/Pause button at this time
will erase the last recorded track.
10
symbol