Operation And Functions - BOLTUNE BT-BH021 Guia Del Usuario

Clear Pairing List
If you failed to pair your device with the earbuds, please clear the pairing
history as instructed below:
1. Place both earbuds in the charging case.
2. Press and hold the Multifunction Touch Control of the left earbud for 10
seconds until the LED indicator on both earbuds flash white three times.
3. If you have paired your device with the earbuds before, remove "Boltune
BT-BH021" from the Bluetooth device list and pair again.
4. Re-pair with your Bluetooth® device as instructed in "Pairing" section.
Note:
If you want to pair the earbuds with another device when you have already
paired them with a device, deactivate the Bluetooth function on the paired
device or clear "Boltune BT-BH021" from its Bluetooth list. Restore the earbuds
to factory settings as instructed above if pairing failed.

OPERATION AND FUNCTIONS

Function Operation
Tap the Touch Control on
Play / Pause
either of the earbuds twice
Tap the Touch Control on the
Volume +
right earbud.
Tap the Touch Control on the
Volume -
left earbud
07
Voice Prompt
/
Toots when highest setting
is reached
/
Tap the Touch Control on the
Next Track
right earbud three times
Tap the Touch Control on the
Previous Track
left earbud three times
Answer Phone
Tap the Touch Control on
Call
either of the earbuds once
Hang up Tap the Touch Control on
Phone Call either of the earbuds twice
Tap and hold the Touch
Decline an
Control on either of the
Incoming Call
earbuds for 2 seconds
When paired successfully,
press and hold the Touch
Turn On / Off
Control on either of the
Voice Control
earbuds for 2 seconds until a
beep is heard
Clear Pairing Refer to the "Clear Pairing
List List" section
Go into Pairing
Refer to the "Pairing" section
Mode
Successfully
paired with
/
your device
Bluetooth out
of Range /
/
Failed to pair
with your device
Note: Only when you are wearing the earbuds can you hear the voice prompt.
/
/
/
/
Call rejected
Toot
/
Pairing
Connected
Disconnected
08