Blowing Operation - DeWalt DXV06P Manual De Instrucciones

ENGLISH
At this time, you should dry or replace the
cartridge lter to eliminate the misting and
possible dripping of liquid around the lid. After
completing a wet pick-up job, raise the hose to
drain any excess liquid into the tank before
shutting off. The interior of tank should be
periodically cleaned.
1. Always disconnect the plug from the wall outlet
before removing the power head. Place power
head in an upside down position. Remove the
cartridge lter by sliding it up and off the
lter cage.
2. Shake excess dust off the cartridge lter with
a rapid up and down movement.
NOTE: WET PICK-UP ACCESSORIES
SHOULD BE WASHED PERIODICALLY,
ESPECIALLY AFTER PICKING UP WET,
STICKY FLUIDS OR SPILLS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION
OF SOAP AND WATER.
3. This wet/ dry vac is equipped with a oat
mechanism which will rise automatically to
cut off the air ow when the liquid in the tank
reaches a predetermined level. When this
happens, turn off vac, unplug the power cord,
and empty the dust tank. You will know that
the oat has shut the air ow off because the
suction ceases and the motor noise becomes
higher in pitch due to increased motor speed.
The liquid capacity may vary with the
rate of pickup.
IMPORTANT: To reduce the risk of damage
to the vac, do not run motor with oat in
raised position.
Float in raised position
NOTE: IF ACCIDENTALLY TIPPED OVER,
THE VACUUM COULD CLOSED SUCTION.
IF THIS OCCURS, PLACE VAC IN UPRIGHT
POSITION AND TURN SWITCH OFF. THIS
WILL ALLOW THE FLOAT TO RETURN TO
ITS NORMAL POSITION, AND YOU WILL BE
ABLE TO CONTINUE OPERATION.
EMPTY THE TANK
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before emptying
the dust tank.
1. Remove the power head assembly of the
wet/ dry vac by pulling outward on the lid
clips located on each side of the vac.
Lift off the power head assembly.
2. Dump the tank contents into the proper
waste disposal container.

BLOWING OPERATION

WARNING:
Always wear safety goggles complying with
ANSI Z87.1 (or in Canada CSA Z94.3) when
using as a blower.
WARNING:
To avoid injury to bystanders, keep them
clear of blowing debris.
CAUTION:
Wear a dust mask if impeller dust which
might be inhaled.
CAUTION:
To reduce the risk of hearing loss, wear
ear protectors when using the vac/blower
for extended hours or when using it in a
noisy area.
The vac contains a blowing feature. It has
the capability to blow sawdust and other
debris. It can be used to blow dust and
debris out of garages or off patios and
driveways. Follow the steps below to use
the vac as a blower.
1. Locate blowing port on the vac.
2. Insert one end of the 1-7/8 in. x 7 ft.
hose into the blowing port.
3. Turn vac "ON".
6