Getting Started; Battery Precautions; Setting Clock Time - HMDX Audio HMDX-SBOX Manual De Instrucciones E Información De Garantía

Thank you for purchasing the HMDX Audio Portable Mini-Boombox, the
ultimate portable iPod speaker dock & radio. This, like the entire HMDX
Audio product line, is built with high-quality craftsmanship to provide
you years of dependable service. We hope you will find it to be the finest
product of its kind.

Getting Started

1. Attach the DC adapter to the DC Jack located in the back of the unit.
2. Plug the cord into a 120V household outlet.
Install/Replace/Remove Battery
Batteries can be used to power the device without the use of the DC
adapter. They are not intended for battery backup in the event of a
power failure. The device will not charge your iPod when being operated
with batteries.
1. Open the battery compartment cover located on the back of the unit.
2. Insert four AA batteries, checking that the positive polarity matches the
picture in the battery housing.
3. Close the compartment cover.

Battery Precautions

1. Use only the size and type of batteries specified.
2. When installing batteries, observe proper +/ – polarities. Incorrect
installation of battery may cause damage to unit.
3. Do not mix different types of batteries together (e.g. alkaline with
carbon-zinc, old batteries with new ones or rechargeable with non-
rechargeable).
2
4. If the unit is not going to be used for a long period of time,
remove batteries to prevent damage due to possible battery
leakage.
Caution: All
5. Do not dispose of batteries in fire. Batteries may explode or
servicing of
leak.
this product
must be 6. Remove used batteries promptly.
performed by
7. Clean the battery contacts and also those of the device
authorized
prior to battery installation.
HMDX Audio
Service
8. Please recycle or dispose of batteries per local regulations.
Personnel only.
9. Warning: Batteries may pose choking hazard. Do not let
children handle batteries.

Setting Clock Time

1. Press the TIME SET button located on the front of the unit
(Fig. 1); hour digit will begin flashing. Press the NEXT/
PREV button until the current hour is displayed. Remember
to set the correct AM or PM (an icon in the upper left of
the time display is the PM INDICATOR; there is no AM
indicator) (Fig. 3).
2. Press the TIME SET button again; minute digits will begin
flashing. Press the NEXT/PREV Button until the current
minute is displayed.
3. Press the TIME SET button again to exit the clock setting
mode or after 3 seconds the display will stop flashing to
indicate the time is set.
3