Replacement Parts List; Care And Maintenance - Style selections LWSMSS Manual De Instrucciones

Ocultar thumbs

Contenido

página de 10

/ 10
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

OPERATING INSTRUCTIONS

2. Locate and mark wood studs where the unit is to be

installed. Drill a 1/8" pilot hole on the wooden stud

behind one upper side frame approximately 3" below

the height of unit top. Attach bracket (a) securely with

screw (c) into the pilot hole on the wall. Adjust floor

levelers to level the unit against the wall where desired

and put the male end of the steel cable (b) through

the bracket (a) and round the back post of upper side

frame. Securely connect both ends together by turning

the female connector clockwise.

Hardware Used

Tipping restraint hardware

CARE AND MAINTENANCE

•

Periodically check to make certain all components are properly positioned, free from damage

and firmly connected.

•

Use a soft, clean cloth that will not scratch the surface when dusting.

•

Never use water to clean the furniture as it may cause damage to the finish.

•

Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.

•

In the event that the furniture is stained or otherwise damaged during use, it is recommended

you call a professional to repair the furniture.

•

Keep furniture away from direct sunlight as it may damage the finish.

•

It is best to keep the furniture in a climate-controlled environment. Extreme temperature and

humidity changes can cause fading, warping, shrinking and splitting of wood.

LIMITED LIFETIME WARRANTY

This product (exclusive of shelves) is warranted to the original purchaser. If there is a failure in

this unit due to defects in materials or workmanship, the manufacturer will repair or replace this

item at our discretion without charge. Warranty is void if product has been assembled incorrectly,

misused, abused by overloading, altered in any way or damaged due to accident. This warranty is

not transferable and does not cover chipping, flaking, scratches, rust, dents, or other damages to

the surfaces of this product. Responsibility of the manufacturer is limited to repair or replacement of

this product. The manufacturer is not responsible for consequential, incidental, or other damages or

losses resulting from product failure.

This warranty is in lieu of all other expressed warranties. Some states do not allow the exclusion or

limitation of incidental or consequential damages, so the above limitation may not apply to you. This

warranty gives you specific legal rights and you may have other rights which vary from state to state.

Wooden stud

Wall

x 1