Health Zenith SL-6136 Manual De Instrucciones página 2

SL-6136
2. Turn off the power to the outlet or lamp to be con-
trolled. Install the switched outlet or lamp module as
shown.
3. For the SL-6136, plug in the device(s) you wish to control. Screw
the light bulb into the SL-6138. Caution: do not exceed the specifica-
tions listed on the next page. Turn the power back on.
4. To check the operation, hold the remote switch at the desired location and
switch it on. The appliance should turn on immediately. Important: Wait at least
3 seconds after you switch the remote switch on or off before you switch it again
to allow the transmission to be completed. Turn the appliance off and back on
several times. If the switch appears unreliable, move the remote switch until the
appliance switches reliably.
5. Mount the remote switch at the desired
location with the two wood screws pro-
vided. Note: Your particular installation may
require different mounting hardware.
6. Install the switch plate on the remote
switch with the screws provided.
-2-
SL-6138