Descargar Imprimir esta página

QuickCable iStart Manual Del Usuario página 4

Ocultar thumbs Ver también para iStart:

Publicidad

Idiomas disponibles

Idiomas disponibles

Use your iStart
• Do not use the portable power pack if any cable clamp or cord is
damaged.
• Do not short circuit the unit. Don't touch the clamps to any
conductive material.
• Always wrap the cables back into position and store the clamps properly.
• If your iStart portable power pack requires service, follow the directions
in the warranty section. Do not attempt to repair the unit or replace parts.
Unauthorized repairs will void your warranty.
• Check vehicle battery terminals before using the power pack; clean them
if necessary.
• After approximately 10 seconds of continuous cranking, if the disabled
vehicle fails to start, stop and wait for 1 minute. This prevents damage to
your power pack and to your vehicle's system from overheating.
• No lubrication is recommended or required.
• Avoid storing in direct sunlight, in extreme heat or cold, or very moist
areas.
4
safely

Publicidad

loading

Productos relacionados para QuickCable iStart