Publicidad
Idiomas disponibles
Idiomas disponibles
Trouble-Shoo ng
Trouble-Sho
Problem
Washing machine fails to operate.
Washing machine cannot be filled
with water.
Machine is draining while being
filled.
Drainage failure.
wash cycle.
Excessive foam in the drum, which is
Spinning fails
Causes
Power failure.
The washer door is not properly closed.
Machine has not been switched on.
Water tap is not turned on.
Water pressure is less than 0,03 MPa.
The inlet hose is kinked.
Water supply failure.
The program knob is not properly set.
The washer door is not properly closed.
The inlet hose filter is blocked.
The height of the drain hose is below
80 cm.
The drain hose is in water.
Drain hose is blocked.
Drain hose end is higher than 100 cm
abovethe floor level.
The filter is blocked.
removed.
Washing machine is located on an uneven
surfaceor is not level.
Machine load is over 8kg.
Water or electricity failure.
Washing machine gives an error message.
Washing machine is in soaking cycle?
The detergent is not a low-foaming type or
for manual wash.
Excessive use of detergent.
adjusted
Unbalance of the laundry
20
Solu ons
Check the power supply.
Close the washer door properly.
Make sure the machine is switched on.
P
Turn on the water tap.
Check water pressure.
Check the inlet hose.
Ensure the water supply.
Set the program knob properly.
Close the washer door properly.
Unblock the inlet hose filter.
Install drain hose within 80-100 cm
of height.
Make sure the drain hose is not in
water.
Unblock the drain hose.
Make sure the drain hose end is lower
than 100 cm above floor level.
Unblock the filter.
Make sure the washing machine is on
an even surface and levelled.
Reduce amount of laundry in the
drum.
Check the power supply or water
supply.
Check display codes.
Check if your detergent is appropriate.
Reduce amount of detergent in the
This is normal and doesn't affect the
Add clothes or run a spinning
program again.
Publicidad
