Publicidad
Idiomas disponibles
Idiomas disponibles
MOTION SENSOR
BATTERY PLACEMENT
1
To have access to battery compartment.
Turn the base as shown below.
HOW TO USE
Slide the switch to select an alert mode. You must wait for 30 seconds until the alert is ready.
When the sensor detects movement will sound according with the alert mode.
Alert type bell (Emits two tones)
Turn off the sensor
Alert (Constant sound)*
* To mute the alarm, slide the switch to OFF.
USER MANUAL
2
Remove the battery compartment cover.
3
Take out the holder and insert a 9V
battery. Ensure that the polarity is right.
IMPORTANT
Before to use the product, please read carefully this manual to avoid any
malfunction. The info in this manual is shown as reference.
Due to updates can exist differences. Consult our website www.steren.com to
obtain the current version of this manual.
CAUTIONS
• Always use a soft and dry cloth to clean it.
• Don't use or store the device in places where exist water or splashes.
• Don't place heavy objects over the
• Avoid dropping the device, it could cause severe damage.
• This product is NOT a toy; keep it away from children.
INSTALLATION OF THE SUPPORT
Carefully remove the base
1
as shown below.
B) Lift up
A) Turn
C) Remove
Drill. Then insert anchors and screws,
3
ensure that the screws sticks out from
the wall some milimetres.
Use the support to make drill marks
2
into the surface where you want to
install the device.
Set the device into the base
4
again and the sensor on the
screws.
SPECIFICATIONS
Input: 9 V - - - (1 x 6LR61)
Motion detection speed: 0.6 – 1.5 m/s
Operating temperature: -20 to 40°C
Consumption: 0.5 W/h
Stand-by power consumption:
Not applicable
Specifications may change without
notice
Publicidad
