Kohler K–2515 Guia De Instalacion página 3

Before You Begin (cont.)
This vanity is designed to allow most base moldings to pass
behind the vanity. Remove any moldings that may inhibit the
vanity from being flush against the finished wall.
Remove the drawers from the vanity before beginning the vanity
installation. Doing so will ease the installation process. Refer to
the "Service the Drawers" section contained in this guide for
proper removal.
Install the water supply and drain lines according to the
roughing-in information. The water supply nipples must extend
3" (7.6 cm) beyond the finished wall material.
Kohler Co. reserves the right to make revisions in the design of
products without notice, as specified in the Price Book.
Kohler Co. 3 1082745-2-A