Bosch Rexroth SB356 Manual Del Usuario página 26

26/124
Adhere to the following instructions
General instructions
Only accessories and add-on units that have
been approved for use in Rexroth tightening
systems may be used therein. Non-approved
components may neither be added nor
connected to the system. The same applies
to cables and lines which belong to the
Rexroth tightening system. Otherwise,
functional and system safety is jeopardized.
Observe the regulations for accident
prevention and environmental protection for
the country where the product is used and at
the workplace.
Exclusively use Rexroth products in good
technical order and condition.
Check the product for visible defects, for
example damage to the circuit board,
components, housing, and plug connectors
or missing screws.
Only use the product within the performance
range provided in the technical data.
Persons who assemble, operate,
disassemble or maintain Rexroth products
must not consume any alcohol, drugs or
pharmaceuticals that may affect their ability
to respond.
The warranty only applies to the delivered
configuration.
The warranty will not apply if the product is
incorrectly assembled or handled or not used
as intended.
Do not expose the product to any mechanical
loads under any circumstances. Never use
the product as a handle or step. Do not place
any objects on it.
Bosch Rexroth AGSB356 | 3 609 929 B67/2008-11
During assembly
Make sure the relevant system component is
not under pressure or voltage before
assembling the product or when connecting
and disconnecting plugs. Protect the system
against being switched on.
Lay cables and lines so that they cannot be
damaged, are in accordance with the
bending radiuses, and no one can trip over
them.
Before commissioning, make sure that all the
connection gaskets and plugs are installed
correctly to ensure that they are leakproof
and fluids and foreign bodies are prevented
from penetrating the product.
During commissioning
Let the product acclimate itself for several
hours before commissioning, otherwise
water may condense in the housing.
Make sure that all electrical connections are
either used or covered. Commission the
product only if it is installed completely.
During cleaning
Cover all openings with the appropriate
protective equipment in order to prevent
detergents from penetrating the system.
Never use solvents or aggressive detergents.
Only clean the product using a slightly damp,
lint-free cloth. Only use water to do this and,
if necessary, a mild detergent.
Disposal
Dispose of the product in accordance with
the currently applicable national regulations
in your country.