DJ-Tech Conrad 30 49 62 Manual De Instrucciones página 8

3 OPERATION
Automatic Operation
•
Record:
Rec. select to TT
Recording to your USB stick
a. Insert a flash-disk (e.g.memory stick, MP3 player) into the USB slot
b. Position the stylus at the track you want to record
c. Press the "CUE UP" button to pause the record player
d. Press the "RECORD" button and wait until the LED will flash (this may take several seconds
depending on the contents on the flash-disk)
e. Press the "CUE DOWN" button and resume playing the track
f. Press the "RECORD" button again to stop the recording process
g. The track is now stored on the flash disk as an 192kbps MP3 file, tracks will be numbered in
sequence and placed into a folder called "audio"
Manual Operation
• Remove the stylus guard from the stylus assembly (Fig.1)
• Put a slipmat on the turntable. If needed, use the 45rpm adaptor (Fig.2)
• Select the size selector to 30 or 17 cm (Fig.3)
• Select the speed button to 33
• Press cue up to raise the tonearm (Fig.7)
• Gently move the tonearm so the stylus is over the point on the record where play is desired to begin
• Press cue down button again to gently lower the tonearm and play record (Fig.7)
Replacing the Stylus
While holding the head of the tone arm, rotate the front of the stylus assembly in a forward and down
motion to remove it.
Make certain that the projection at the back of the assembly is fully seated in the cartridge body first,and
that the assembly "clicks" up into place, with no gap between its top edge and the front of the black
plastic tonearm head.
1
/ or 45 rpm (Fig.4)
3
Engage in
body first
7
No gap here