Vimar ELVOX 7200 Serie Guia Del Usuario página 6

7200
E N G L I S H
Front panel commands and controls
A) 7" TFT LCD colour screen, 16:9 aspect ratio
B) Microphone
C) Loudspeaker
D) Pair of push-buttons "
activation of auxiliary functions or intercom calls and for con-
trast control (when display is switched on), conversation vol-
ume and ringtone volume (when display is switched off).
E) Pair of push-buttons "
activation of auxiliary functions or intercom calls and for bright-
ness control (when display is switched on) and melody selec-
tion (when display is switched off).
F) Push-button
of the speech unit camera or a standalone camera (pro-
grammed on the entrance panel) and/or to enter setting mode.
G) Push-button : for auxiliary service, 1st relay of 1st
actuator type 69RH (e.g. stair lights).
H) Push-button
I) Talk/listen push-button: to communicate with the
speech unit on receiving a call or after self-start or to commu-
nicate with intercom devices. The default conversation mode is
"HANDS FREE". Alternatively the unit can be set to push-to-
talk mode (see paragraph "Communication mode selection
function").
6
" and "
" and "
: for monitor self-start on activation
: for door lock release.
L) Ringtone mute indicator: if the red LED lights up, this
indicates that the call tone is off. The red LED also remains on
throughout the conversation, e.g. as long as the audio connec-
tion is active.
M) Door open indicator: if the green LED lights up, this
indicates that the door is open (this function is optional
": for
depending on the type of installation). If the green LED is
flashing, this also indicates setting mode, enabling the bright-
ness, contract, volume or melody to be adjusted using the
arrow buttons "
": for
".
SETTINGS
Ringtone volume and melody selection functions
These settings can be adjusted with the display switched off.
Press push-button
green LED at the bottom right flashes. This LED is normally
used to indicate DOOR OPEN. This flashing indicates "SETTING"
mode, during which buttons
adjust the ringtone volume and push-buttons
to select the melody.
The monitor will remain in "SETTING" mode (green LED flashing)
until the arrow buttons are pressed.
SETTING mode is cancelled when the arrow buttons are not
, , " and "
(self-start) for 2 seconds, until the
and can be used to
and
EN