7200
received from the speech unit or intercom device, without the need
to push the TALK/LISTEN button
condition is indicated by the illumination of the red LED
the bottom left corner of the monitor, which is normally used to
indicate RINGTONE MUTE. The audio is activated automatically
5 seconds after the call is received. To enable this function, with
the monitor switched OFF press push-button
seconds to enter SETTING mode; simultaneously press and hold
down push-buttons
underneath starts flashing. At this point, while the LED is flashing,
press the TALK/LISTEN push-button
change.
The function is confirmed if the red LED switches off. To disable
this function, follow the same procedure. If HANDS FREE mode
was not active during the enabling process, it will be activated
automatically when the AUTOMATIC ANSWER function is ena-
bled. If the automatic answer function is subsequently disabled,
the HANDS FREE function will remain active.
Adjusting the conversation volume
The term "conversation volume" refers to the perceived volume of
the caller's voice when he/she is standing in front of the speech unit
(entrance panel), or speaking through an intercommunicating inter-
phone or monitor. To adjust the conversation volume, the user
must be in communication with a speech unit or intercom device.
Press push-button
mode; once the green LED
8
. The "audio active"
and
until the red LED
to confirm the
for 2 seconds to enter SETTING
starts flashing, press and hold
the TALK/LISTEN push-button
push-buttons
in HANDS FREE mode and in PUSH-TO-TALK mode.
at
for 2
and adjust the volume with
and
. This procedure applies both
EN