Battery Charger Preparation; Battery Charger Installation And Connection; Machine Preparation - GGMgastro BSW2200 Manual De Instrucciones

"SUCTION UNIT ON" within two seconds from when
the machine is switched on. The second speed indicating
LED on the left should be ON.
2) Press the "INCREASE SPEED" key within 5 seconds
from the previous action. When you release the key
you enter the configuration mode wanted.
THE CONFIGURATION SETTINGS ARE VISIBLE
ON THE SPEED INDICATION LEDS:
1) The first two LEDs indicate the type of setting of the
indicator intervention threshold and both must be ON;
2) The third and fourth LEDs indicate the type of battery;
for the Pb-Acid type only the third LED should be ON
while for the Gel type both should be ON;
If you do not complete the configuration cycle, the
settings remain as they were originally.
We recommend calling the assistance centre or a
technician if you have problems with the settings given.
Do not open and tamper with the electrical circuit.

6.4 BATTERY CHARGER PREPARATION

To use the battery charger you first have to check that
If the battery charger and battery settings do
not correspond, do not connect or charge the battery
and contact the authorised assistance centre.
Once the battery charger has been correctly
programmed, follow the procedure described in the
specific section.

6.6 MACHINE PREPARATION

Before starting to work, wear non-slip shoes, gloves
and any other personal protection device indicated by
the supplier of the detergent used or considered
necessary based on the operating environment.
Do the following before starting to work. Refer to
the relative sections for a detailed description of these
steps:
30
TO MODIFY CONFIGURATION SETTINGS:
1)The "INCREASE SPEED" and "REDUCE SPEED"
keys are used to set the indicator's intervention threshold
in such a way that the first two speed indication LEDs
turn on;
2)The "BRUSHES ON" and "SUCTION UNIT ON" keys
are used to select the type of battery, Pb-Acid or Gel
respectively;
TO SAVE THE SETTINGS AND EXIT THE MODE:
Press the "REDUCE SPEED" and "SUCTION UNIT
ON" keys simultaneously.
Once the settings are finished, we have different run-
down battery levels, with differentiated interventions on
the moving parts, and more specifically:
the connector on the machine is the same as the one
on the battery charger.
6.5 BATTERY CHARGER INSTALLATION AND
CONNECTION
The battery charger is generally supplied ready to use
if requested with a specific battery. Make sure that the
battery charger was correctly programmed to charge
the battery supplied: check the voltage.
heck the battery charge level and charge, if necessary.
(PHOTO C-33)
Mount the brushes or scraper disks (with the abrasive
disks) that are suitable for the surface and work involved.
(PHOTO G-60)
Mount the squeegee, check that it is solidly attached
and connected to the suction hose and that the drying
straps are not too worn. (PHOTO D)
Make sure that the recovery tank is empty. If not, empty
it completely. (PHOTO B-23)
Check and completely close the detergent solution
release control. (PHOTO B-24)
Fill the detergent solution tank with a mix of clean water
and non-foaming detergent in an adequate concentration
through the anterior hole (PHOTO A-3). Leave 2 cm