Cmt Worktop Jig Configuration - CMT ORANGE TOOLS CMT650 Manual De Instrucciones

For precise positioning on the worktop, the CMT worktop jig is fitted with three steel stops fitted into
specific holes in the jig to suit each specific operation.
Each stop is fitted with two neoprene o-rings to hold it securely into the hole. If the stop is difficult to
fit, apply a drop of oil or soap to the o-rings.
Ensure that the stops are pushed fully into the holes flush to the underside of the jig.
F
B
The holes for the steel stops are indicated by letters for each specific operation
A. 2 holes - outer part of 45° joint
B. 2 holes - outer part of 90° joint
C. 4 holes - inner part of 90° and 45° joints
D. 4 holes - fixing holes for clamps
E. 3 holes - radius finishing of corners (r8,2)
F. 2 holes - 45° finishing of corners
G. 1 hole - inner part of 45° joint
H. 1 hole - inner part of 90° joint (worktop 500, 550, 600, 616, 650mm only)
NOTE: The CMT jig must be used with a 30mm guide bush and a 12mm cutter fitted to
the router. This allows for a cutter offset from the edge of the jig of 9 mm.
www.cmtutensili.com

CMT worktop jig configuration...

C
D
H
E
D
E
G
A
7