Cutting 90 Degree Worktop Joints - CMT ORANGE TOOLS CMT650 Manual De Instrucciones

Cutting 90 degree worktop joints...

PLEASE NOTE!!!
When cutting a 90-degree joint to the right hand end of the worktop, have the
worktop (decorative laminate) face up. For the matching male joint turn the worktop face down.
When cutting a 90-degree joint to the left hand end of the worktop, have the worktop (decorati-
ve laminate) face down. For the matching male end joint turn the worktop face up.
The first step is to set the jig to suit the width of the worktop. If it is a standard 600mm worktop, then
stop position H can be used. If there is any discrepancy in the exact width or if the worktop is wider or
narrower than this then the sliding width stop must be used.
www.cmtutensili.com
9