Caster Installation - Craftsman 714.58647 Manual De Instrucciones

warranted against defects in material or workmanship.
10mm Wrench
14mm Wrench
NOTE Not all assembly instructions will relate to your model.
SIDE HANDLE ATTACHMENT
M6 x 12 Hex Bolt
10mm Wrench
• Position the handle over the holes and
with the bolts provided. Tighten securely only
by hand. Do not overtighten.
from the date of sale this product is
HARDWARE
M6 x 12 Hex Bolt
) 4
M8 x 20 Hex Bolt
16)
Washers
16)
Connection Brackets
(Qty: 2)
M6 x 12 Hex Bolt
(Qty: ) 2
attach

CASTER INSTALLATION

Items Needed:
M8 x 20 Hex Bolt (Qty: 16)
Washer 16)
14mm Wrench
This procedure may require the help of an assistant.
• Take out casters from the bottom left drawer.
• Lay cardboard from shipping box on floor. Lay the
cabinet down on its back on the cardboard to protect
paint finish.
• Attach a swivel caster to each bottom corner of the
workstation cabinet using (4) M8 x 20 Hex Bolts and (4)
washers per caster.
• Wrench tighten all screws.
• Return the cart to its upright position.
CHEST AND CABINET CONNECTION
• Remove all drawers from the chest before placing the
chest on the top of the cabinet.
• Place the chest on the cabinet. Connect the chest and
cabinet together with the connection brackets. Insert the
bracket hook into the slot in the chest. Use the bolt to
secure the bracket to the cabinet as shown.
M6 x 12 Hex Bolt (Qty: 2)
Connection Brackets (Qty: 2)
10mm Wrench
2