Midwest Hen Haven Chicken Coop 62COOP Instrucciones De Montaje página 4

Lay the Long Solid Front Panel flat on the ground with
5.
the screw holes facing up. Lay the Wire-Mesh Lift Top
next to the Front Panel, aligning the hinges with the holes
in the Front Panel. Use the Lift Top Screws and a Phillips
screwdriver or power drill to connect them.
With a helper holding the Lift Top, place the Long
6.
Solid Front Panel across the wire mesh run, attaching it
to the Gabled Panel (Right) by inserting the pegs of the
Long Panel into the holes of the Gabled Panel. The clips
of the Lift Top will rest on each of the Side Panels,
keeping it in place. Insert Cotter Pins at each connection
point to secure the pegs in place.
Place the Long Solid Back Panel on top of the Short
7.
Wire-Mesh Back Panel, attaching it to the Gabled Panel
(Right) by inserting the pegs of the Long Solid Panel into
the holes of the Gabled Panel. Insert Cotter Pins at each
connection point to secure the pegs in place. NOTE:
There will be a temporary gap, as this Panel allows
space for the insertion and removal of the Floor
Tray.
Place the Gabled Panel (Left) on top of the Long
8.
Wire-Mesh Left Panel, aligning the Gabled Panel's track
with the track of the Long Wire-Mesh Panel. The pegs of
the Gabled Panel will fit into the holes of the Long
Wire-Mesh Panel. Then, insert the pegs of both Long
Solid Panels into the Gabled Panel. Insert Cotter Pins at
each connection point to secure the pegs in place.
4