Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS LIST
Z. WALL ANCHOR SAFETY CABLE
Wall Anchor...................................................................................................... 1
Screw for wall anchor ...................................................................................... 1
Screw for mantel ............................................................................................. 1
Safety cable .................................................................................................... 1
CAUTION: Carefully move the assembled unit to the desired location. The fireplace
mantel should not be positioned in an area exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of wall anchor safety cable is highly recommended in order to reduce the risk of
the fireplace being tipped over accidentally.
WARNING: This cable may reduce possible risk of injury if the fireplace is
improperly handled, but is not a substitute for proper adult supervision.
Children should not be left unattended near any heater.
1. Drill a 5/16" (8 mm) hole in the wall. Insert the plastic wall anchor into the hole and
gently tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantel close to the wall.
3. Attach the safety cable to the mantel using the screw for mantel. See fig. A.
4. Use the screw for wall to attach the other end of safety cable to the wall.
5. Make sure all screws are tight.
Fig. A
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 watts. Once the fireplace insert
has been properly connected to a grounded electrical outlet, it is ready to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
WARNING: DO NOT TOUCH. HOT SURFACE AT CENTRE OF GRILL. HOLD LEFT OR
RIGHT SIDE OF THE GRILL WHEN PULLING OUT.
0/I: Press this button for main power and flame effect. The indicator light will be on. See
below for other control switches.
1250W: For heat function - press this switch while the 0/I switch is in the ON position.
The indicator light will be ON.
Temperature Control: To adjust the temperature to your individual requirements, turn
the temperature control dial to the right (clockwise) to increase the desired temperature
and to the left for lower temperature. This temperature control dial can only be used while
the 0/I switch and 1250W switches are in the ON position.
Note: When the O/I switch is turned off, all other heater functions will stop even though
the switches may be in the on position.
MAINTENANCE
WARNING: Disconnect power and unplug the power cord before attempting any
maintenance or cleaning to reduce the risk of fire, electric shock or damage
to persons. The bulbs in your unit can become extremely hot. Allow at least 10
minutes between turning off the unit and removing the light bulbs to avoid the
accidental burning of the skin.
RISK OF FIRE: DO NOT EXCEED THE RECOMMENDED BULB WATTAGE.
2
Publicidad
